Samwon Tech TEMP880S - Page 21

SAMWONTECH
1st Edition of TEMP880S IM : Sep. 21. 2005 Page 19 / 101
2.1.2 SETTING VALUE INPUT KEY
▶ If you press setting value input button on general setting button as above(table 1-1), setting
▶ value input key appears and you can enter data.
▶ If you enter data that exceeds input range, error message appears(“-LIMIT ERR”) with beeping
▶ sound.
○
1 INPUT KEY ONLY FOR SETTING NUMBERS
○
2 INPUT KEY FOR SETTING DI ERROR NAMES
○
3 INPUT KEY FOR TIME SIGNAL SETTING
▶ Setting value does not get entered when key lock is turned on, enter after turn off key lock.
☞ Refer to 2.7 ACTION SETTING SCREEN
for detail.
2.1.3 VALIDITY FOR SETTING BUTTON AND SETTONG VALUE
▶ The product is made to check validity of entered setting value by making beeping noise.
☞ "beep" : when press general setting button and setting value is entered correctly.
☞ "beep-bleep" : Data entered by setting value input key exceeds the range.
▶ Do not press general setting button and setting value input key with sharp thing(such as
▶ pencil) or nail. Or, the product may show bad operation or touch swich may be damaged.
Touch Key Lock Removal
Caution