Samwon Tech TEMP880S User Manual

SAMWONTECH
1st Edition of TEMP880S IM : Sep. 21. 2005 Page 82 / 101
4.3.2 Communication Command Type
▶ The Communication Command of TEMP880Shas a Self Information Command which reads the
▶ information of Communication Command and a Read/Write Command which reads all the information of
▶ TEMP880S.
○
1 Self Information Command
COMMAND Contents
AMI Indicate the model name & version of TEMP880S
○
2 Read/Write Command
COMMAND Contents
RSD Series Read of D-Register
RRD Random Read of D-Register
WSD Series Write of D-Register
WRD Random Write of D-Register
STD Random Registration of D-Register
CLD Call of D-Register which is registered at STD
☞ Each Command can read or write D-Register up to the number of 32. And it should be re-registered
☞ after the power is on in case of STD/CLD when its power source’s off because the registered contents
☞ are initialized.
4.3.3 Error Response
▶ TEMP880S transmits a message as below in case of Error during a Communication.
The number of Byte 1 2 2 2 2 1 1
S
T
Contents
X
Address NG
Two
numbers
SUM
C
R
L
F
☞ SUM is only used in case the PROTOCOL is “PCL1”.

Samwon Tech TEMP880S Specifications

General

Brand	Samwon Tech
Model	TEMP880S
Category	Temperature Controller
Language	English