Samwon Tech TEMP880S - 4.3.9 CLD Command

SAMWONTECH
1st Edition of TEMP880S IM : Sep. 21. 2005 Page 88 / 101
4.3.9 CLD Command
▶ CLD Command is used for reading & bring the D-Register which is already registered at TEMP880S by
▶ STD Command.
▶ Formate of Transmission
The number
of Byte
1 2 3 2 1 1
S
T
Contents
X
Addr CLD SUM
C
R
L
F
▶ Response
The number
of Byte
1 2 3 1 2 1 4 1 4 1 …
S
T
Contents
X
Addr CLD , OK , dddd-1 , dddd-2 , …
1 4 1 4 2 1 1
C L
, dddd-(n-1) , dddd-(n) SUM
R F
- Number : 1~32
- dddd : Data without a point of 16 number