Sanyo PLC-WL2500 - Remote Control Battery Installation; Remote Control Operating Range; Remote Control Code

12
Part Names and Functions
Toensuresafeoperation,pleaseobservethefollowingprecautions:
● Usetwo(2)AAAorLR03typealkalinebatteries.
● Alwaysreplacebatteriesinsets.
● Donotuseanewbatterywithausedbattery.
● Avoidcontactwithwaterorliquid.
● Donotexposetheremotecontroltomoistureorheat.
● Donotdroptheremotecontrol.
● Ifthebatteryhasleakedontheremotecontrol,carefullywipethecasecleanandinstallnewbatteries.
● Riskofanexplosionifbatteryisreplacedbyanincorrecttype.
● Disposeofusedbatteriesaccordingtotheinstructionsoryourlocaldisposalruleorguidelines.
Openthebattery
compartmentlid.
Installnewbatteries
intothecompartment.
Replacethe
compartmentlid.
Two AAA size batteries
Forcorrectpolarity
(+and–),besure
batteryterminalsare
incontactwithpinsin
compartment.
1 2 3
Pointtheremotecontroltowardtheprojector(Infrared
RemoteReceiver)whenpressingthebuttons.Maximum
operatingrangefortheremotecontrolisabout16.4'(5m)
and60degreesinfrontoftheprojector.
Remote Control Operating Range
Remote Control Battery Installation
Remote Control Code
Thetwodifferentremotecontrolcodes(Code 1 -Code 2)areassignedtothisprojector.Switchingtheremote
controlcodespreventsinterferencefromotherremotecontrolswhenseveralprojectorsorvideoequipment
nexttoeachotherareoperatedatthesametime.Changetheremotecontrolcodefortheprojectorfirstbefore
changingthatfortheremotecontrol.See"Remotecontrol"intheSettingMenuonpage54.
PressandholdtheMENUandIMAGEbuttonsformore
thanfivesecondstoswitchbetweentheCode 1 and Code
2.TheinitialcodeissettoCode 1.
HDMI
ASPECT
MENU button
IMAGE button
WhilepressingtheMENU
button,presstheIMAGE
buttonmorethanfive
secondstoswitchbetween
thecodes.
16.4’
(5m)