Sanyo PLC-WL2500 - Computer Input; Input Source Selection (Computer 1: RGB)

27
HDMI
ASPECT
ChooseComputer 1(RGB)bypressingtheCOMPUTER1
buttonontheremotecontrolorpresstheINPUTbuttonon
thetopcontrol.
Beforeusingthesebuttons,correctinputsourceshouldbe
selectedthroughMenuoperationasdescribedbelow.
1
Input Menu
2
3
Input Source Selection (Computer 1: RGB)
Computer Input
COMPUTER 1 button
Note:
  WhentheInputSearchfunctionissettoOn 1orOn 2in
theAutosetupfunction,theinputsignalwillbesearched
automatically(p.45).
Computer
1
Remote Control
PresstheMENUbuttontodisplaytheOn-Screen
Menu.UsethePoint▲▼buttonstoselectInputand
thenpressthePoint
►
ortheSELECTbutton.
UsethePoint▲▼buttonstoselectComputer 1.
WhenComputer 1isselected,pressthePoint
►
to
accessthesubmenuitems.UsethePoint▲▼buttons
toselecttheRGBinputsourceandthenpressthe
SELECTbutton.
Computer 1(RGB)
Computer 1(Scart)
Direct Operation
Menu Operation
INPUT button
Top Control
*
COMPUTER2cannotbeselectedwhenusingthe
COMPUTERIN2/MONITOROUTterminalasMONITOR
OUToutput.
Computer 1
Computer 2 *
HDMI
Video
S-video