Sanyo PLC-WL2500 - Information

59
Input Source Information Display
TheInformationMenuisusedforcheckingthestatusoftheimagesignalbeingprojectedandtheoperationof
theprojector.
H-sync freq.
V-sync freq.
Lamp counter
Information Menu
Thehorizontalfrequencyoftheinputsignalisdisplayedin
KHz,or- - - -KHzwhennosignal.
TheverticalfrequencyoftheinputsignalisdisplayedinHz,
or- - - - Hzwhennosignal.NumbersofHzdoubleswhen
duringInterlace.
Thecumulativelampoperatingtimeisdisplayed.
PresstheINFO.buttonontheremotecontroltodisplaythe
InformationMenu.
HDMI
ASPECT
INFO. button
Remote Control
PressthePoint
▲▼
buttonstoselecttheInformation.The
InformationMenuisdisplayed.
Seebelowfordisplayedinformation.
Power management
Screen
Off,Ready,Shut downorTimerisdisplayed.
Theselectedscreensizeisdisplayed.
Input
Lamp status
Theselectedinputsourceisdisplayed.
Theselectedlampmodeisdisplayed.
Information
Language
Theselectedlanguageisdisplayed.
PIN code lock
OfforOn 1orOn 2isdisplayed.
Remote control
Theselectedremotecodeisdisplayed.
Direct Operation
Menu Operation
Key lock
TheselectedKeylockiconisdisplayed.