Sanyo PLC-WL2500 - Video Input; Input Source Selection (Video, S-video)

37
ChooseVideoorS-videobypressingtheVIDEObutton
ortheS-VIDEObuttonontheremotecontrolorpressthe
INPUTbuttononthetopcontrol.
Beforeusingthesebuttons,correctinputsourceshouldbe
selectedthroughMenuoperationasdescribedbelow.
1
2
Input Menu
Input Source Selection (Video, S-video)
Video Input
When video input signal is connected to the
VIDEOjack,selectVideo.
Video
When video input signal is connected to the S-
VIDEOjack,selectS-video.
S-video
Note:
  WhentheInputSearchfunctionissettoOn 1orOn 2in
theAutosetupfunction,theinputsignalwillbesearched
automatically(p.45).
HDMI
ASPECT
Remote Control
VIDEO button
PresstheMENUbuttontodisplaytheOn-Screen
Menu.UsethePoint
▲▼
buttonstoselectInputand
thenpressthePoint
►
ortheSELECTbutton.
UsethePoint
▲▼
buttonstoselecteitherVideoor
S-videoandthenpresstheSELECTbutton.
S-VIDEO button
Video
S-video
Direct Operation
Menu Operation
INPUT button
Top Control
Computer 1
Computer 2 *
HDMI
Video
S-video
*
COMPUTER2cannotbeselectedwhenusing
theCOMPUTERIN2/MONITOROUTterminal
asMONITOROUToutput.