Sanyo PLC-WL2500 - Appendix; Troubleshooting

65
Lamp replacement counter
Reset?appears.
Problem: –Solutions
No power –PlugthepowercordoftheprojectorintotheACoutlet.
  –SeeifthePOWERindicatorlightsred.
  –WaituntilthePOWERindicatorstopsblinkingtoturnontheprojector
again.TheprojectorcanbeturnedonafterthePOWERindicator
turnsred.Seepage18.
  –ChecktheWARNINGindicator.IftheWARNINGindicatorlightsred,
projectorcannotbeturnedon.Seepage60.
  –Checktheprojectionlamp.Seepage63.
–UnlocktheKeylockfunctionfortheprojector.Seepage55.
The initial display is not shown. –MakesureOfforCountdown offarenotchosenatdisplay 
function.Seepage46.
The initial display is not same –MakesureUserorOffarenotchosenatLogo(select)
as the default set. function.Seepage47.
Input signal switches automatically. –MakesureInputsearchfunctionisadjustedproperly.Seepage45.
(or does not switch automatically)
An icon other than Input mode or –ThatistheFilterwarningiconortheLampreplacementicon.See
Lamp mode icon appears. page58or63.
Image is out of focus. –Adjustfocusoftheprojector.Seepage23.
  –Provideproperdistancebetweentheprojectorandtheprojection
   screen.Seepage13.
  –Checktheprojectionlenstoseeifitneedscleaning.Seepage62.
  –Movingtheprojectorfromacooltowarmplacemayresultin 
   moisturecondensationontheprojectionlens.Insuchcases,leave
   theprojectoroffandwaituntilcondensationevaporates.
Image is Left/Right reversed. –ChecktheCeiling/Rearfunction.Seepage50.
Image is Top/Bottom reversed. –ChecktheCeilingfunction.Seepage50.
Picture is not bright enough. –CheckiftheContrastorBrightnessisadjustedproperly.See
   pages34,41.
  –CheckifImagemodeisselectedproperly.Seepages33,40.
  –Checkthelampcontrolfunction.Seepages25,54.
  –ChecktheLAMPREPLACEindicator.Ifitlights,theendoflamplife
   isapproaching.Replacethelampwithanewonepromptly.Seepage
   63.
Appendix
Troubleshooting
Beforecallingyourdealerorservicecenterforassistance,checktheitemsbelowonceagain.
–Makesureyouhaveproperlyconnectedtheprojectortoperipheralequipmentasdescribedonpages14-16.
–MakesureallequipmentisconnectedtoACoutletandthepoweristurnedon.
–Whentheprojectordoesnotprojectanimagefromtheconnectedcomputer,restartthecomputer.