Sanyo PLC-WL2500 - Image Button; Screen Button

26
PresstheNOSHOWbuttonontheremotecontroltoblack
outtheimage.Torestoretonormal,presstheNOSHOW
buttonagainorpressanyotherbutton.Whentheprojected
imageiscapturedandissetasUserintheLogoselection
(p.47),thescreenchangeseachtimeyoupresstheNO
SHOWbuttonasfollows.
blackout→thecapturedimage→normal→•••••
NO SHOW button
PresstheP-TIMERbuttonontheremotecontroltooperate
theCountup/Countdownfunction.Refertop.52fordetailof
SettingfortheP-timerfunction.
Tostopthecounttime,presstheP-TIMERbutton.
TocanceltheP-timerfunction,pressandholdtheP-TIMER
buttonforafewseconds.
P-TIMER button
PresstheIMAGEbuttonontheremotecontroltoselecta
desiredimagemodeofthescreen.Seepages33,40for
details.
IMAGE button
No showdisappearsafter4seconds.
Note:
Seethepreviouspageforthedescriptionof
otherbuttons.
HDMI
ASPECT
IMAGE button
NO SHOW button
P-TIMER button
SCREEN button
Selectthescreensize(Seepages35-36,43fordetails).
SCREEN button
Basic Operation
Remote Control
Note:
 WhenusetheMUTEbuttontoreleasetheNoShowfunction,
themutefunctioncannotbeoperatedatthesametime.