Sanyo PLC-WL2500 - Connecting the AC Power Cord

17
Installation
Connecting the AC Power Cord
Thisprojectorusesnominalinputvoltagesof100-240VAC
anditautomaticallyselectsthecorrectinputvoltage.Itis
designedtoworkwithsingle-phasepowersystemshavinga
groundedneutralconductor.Toreducetheriskofelectrical
shock,donotplugintoanyothertypeofpowersystem.
Ifyouarenotsureofthetypeofpowerbeingsupplied,
consultyourauthorizeddealerorservicecenter.
Connecttheprojectorwithallperipheralequipmentbefore
turningiton.

Note:
UnplugtheACpowercordwhentheprojectorisnot
inuse.Whenthisprojectorisconnectedtoanoutlet
withtheACpowercord,itisinStand-bymodeand
consumesalittleelectricpower.
ConnecttheACpowercord(supplied)tothe
projector.
CAUTION
TheACoutletmustbenearthisequipmentandmustbe
easilyaccessible.
TotheACoutlet.
(200 - 240 V AC)
NOTE ON THE POWER CORD
ACpowercordmustmeetrequirementofthecountrywhereyouusetheprojector.
ConfirmtheACplugtypewiththechartbelowandproperACpowercordmustbeused.
IfsuppliedACpowercorddoesnotmatchyourACoutlet,contactyoursalesdealer.
Topowercord
connectoronyour
projector.
Projector side
AC outlet side
Ground
TotheACoutlet.
(120 V AC)
For the U.S.A. and Canada
TotheACoutlet.
(200 - 240 V AC)
For the U.K.For Continental Europe
Ground