Sanyo PLC-WL2500 - Page 32

32
Store
Tostoretheadjusteddata,selectStoreandthenpressthe
Point►ortheSELECTbutton.Movethehighlighttoone
oftheModes1to10inwhichyouwanttostore,andthen
presstheSELECTbutton.
Mode free
Toclearthestoreddata,selectMode freeandthenpress
thePoint►ortheSELECTbutton.Movethehighlighttothe
ModethatyouwanttoclearandthenpresstheSELECT
button.
Note:
• Display area (H/V) cannotbeselectedwhen480i,
575i,480p,575p,720p,1035i,or1080iisselectedin
thePCSystemMenu(p.29).
 •Wheninputcomputersignaltotheprojector,PC adjust
willbecomeavailable.
Reset
To reset the adjusted data, select Reset and press the
SELECTbutton.Aconfirmationboxappearsandthenselect
Yes.Alladjustmentswillreturntotheirpreviousfigures.
ThisModehasstored
parameters.
ValuesofTotal dots,Horizontal,
Vertical,Display area H,and
Display area V.
Computer Input
Mode free Menu
Vacant
PressSELECTbuttonto
storeadjusteddata.
PressMENUbutton
toclosethisdialog
box.
Store Menu