Sanyo PLC-WL2500 - Page 48

48
Capture
Capture
Thisfunctionenablesyoutocaptureanimagebeing
projectedtouseitforastarting-updisplayorintervalof
presentations.
SelectCaptureandpresstheSELECTbutton.
AconfirmationboxappearsandselectYestocapturethe
projectedimage.
Aftercapturingtheprojectedimage,gototheLogoselect
functionandsetittoUser.Thenthecapturedimagewillbe
displayedthenexttimeyouturnontheprojector.
Tocancelthecapturefunction,selectYesinthe"Quit?"
confirmationbox.
Note:
 •Beforecapturinganimage,selectStandardinthe
ImageselectMenutocaptureaproperimage(pp.33,
40).
 •AsignalfromacomputercanbecaptureduptoWXGA
(1280x800).Asignalfromvideoequipmentcanbe
capturedexceptfor720p,1035i,and1080i.
 •Whencapturingtheimagethathasbeenadjustedby
theKeystonefunction,theadjusteddataisautomatically
resetandtheprojectorcapturesanimagewithout
keystonecorrection.
 •WhenLogoPINcodelockfunctionissettoOn,Logo
select andCapture cannotbeselected.
 •Whenstartingtocaptureanewimage,thepreviously
storedimageisclearedevenifyoucancelthecapturing.
•Whenthereisnocapturedimageoritisinterrupted
whilecapturinganimage,UserisnotincludedinLogo
SelectMenu,youcanonlyswitchbetweenDefaultand
Off.
Logo PIN code lock
Thisfunctionpreventsanunauthorizedpersonfromchanging
thescreenlogo.
Off........... Thescreenlogocanbechangedfreelyfromthe
LogoMenu(p.47).
On...........Thescreenlogocannotbechangedwithouta
LogoPINcode.
IfyouwanttochangetheLogoPINcodelocksetting,press
theSELECTbuttonandtheLogoPINcodedialogbox
appears.EnteraLogoPINcodebyfollowingthestepsbelow.
TheinitialLogoPINcodeissetto“4321”atthefactory.
Logo PIN code lock
Setting
Note:
 WhenLogoPINcodelockfunctionissettoOn,Logo
select andCapture cannotbeselected.