Sanyo PLC-XE33

47
Setting
Capture
Capture
Thisfunctionenablesyoutocaptureanimagebeing
projectedtouseitforastarting-updisplayorintervalof
presentations.
SelectCaptureandpresstheSELECTbutton.
AconfirmationboxappearsandselectYestocapturethe
projectedimage.
After capturing the projected image, go to the Logo select
functionandsetittoUser.Thenthecapturedimagewillbe
displayedthenexttimeyouturnontheprojector.
Tocancelthecapturefunction,selectYesinthe"Quit?"
confirmationbox.
Note:
 •Before capturing an image, select Standard in the
Image select Menu to capture a proper image (pp.32,
39).
 •A signal from a computer can be captured up to XGA
(1024 x 768).A signal from video equipment can be
capturedexceptfor720p,1035i,and1080i.
 •When capturing the image that has been adjusted by
theKeystonefunction,theadjusteddataisautomatically
reset and the projector captures an image without
keystonecorrection.
 •WhenLogo PIN code lockissettoOn,capturecannot
beselected.
 •When starting to capture a new image, the previously
storedimageisclearedevenifyoucancelthecapturing.
•When there is no captured image or it is interrupted
whilecapturinganimage,Usercannotbeselected,you
canonlyswitchbetweenDefaultandOff.
Logo PIN code lock
Thisfunctionpreventsanunauthorizedpersonfrom
changingthescreenlogo.
 Off........... Thescreenlogocanbechangedfreelyfrom
theLogoMenu(p.46).
 On...........Thescreenlogocannotbechangedwithouta
LogoPINcode.
IfyouwanttochangetheLogo PIN code locksetting,
presstheSELECTbuttonandtheLogoPINcodedialog
boxappears.EnteraLogoPINcodebyfollowingthesteps
below.TheinitialLogo PIN codeissetto“4321”atthe
factory.
Logo PIN code lock
Off
Quit?
Off
Quit?
Downloaded From projector-manual.com Sanyo Manuals