Sanyo PLC-XU115 User Manual

66
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
Ifproblemsstillpersistafterfollowingalloperatinginstructions,contactthedealerwhereyoupurchasedthe
projectorortheservicecenter.Specifythemodelnumberandexplainabouttheproblem.Wewilladviseyou
howtoobtainservice.
This symbol on the nameplate
means the product is Listed
by Underwriters Laboratories
I n c .  I t  i s  d e s i g n e d  a n d
manufactured to meet rigid
U.L. safety standards against
r i s k o f f i r e , c a s u a l t y a n d
electricalhazards.
The CE Mark is a Directive conformity
markoftheEuropeanCommunity(EC).
Appendix
Pixelworks ICs used.
Downloaded From projector-manual.com Sanyo Manuals

Sanyo PLC-XU115 Specifications

General

Projection distance	0.93/11.47 m
Vertical scan range	50 - 100 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	LCD
Contrast ratio (typical)	500:1
Projector native resolution	XGA (1024x768)
Keystone correction, vertical	-40 - 40 °
I/O ports	SD Card Slot
Audio input	1
Aspect ratio	4:3
Special features	Soft Carry Bag
Networking features	Ethernet & Wireless
F-number (relative aperture)	1.7
Lamp type	NSH
Lamp power	275 W
Light source type	Lamp
Service life of light source	2000 h
Service life of light source (economic mode)	3000 h
Dot clock scanning frequency	140 MHz
Analog signal format system	NTSC, PAL, SECAM
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Power consumption (typical)	266 W

Weight and Dimensions

Package weight	3500 g