EasyManuals Logo

Sanyo PLC-XU115 User Manual

Sanyo PLC-XU115
78 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #65 background imageLoading...
Page #65 background image
65
Appendix
The image is distorted or runs off. –Check"PCadjustment"menuor"Screen"menuandadjustthem.
(page33-34,38-39)
PIN code dialog box appears –PINcodelockisbeingset.EnteraPINcode(the“1234”ornumbers
at start-up. youhaveset).Seepages22,54–55.
Page Up/Down function does –MakesureyourcomputerisconnectedtotheprojectorwithUSB
not work. cable.(seepage19)
–Checkcableconnectionbetweentheprojectorandyourcomputer.
(seepage19)
The Remote Control does –Checkthebatteries.
not work. –Makesurenoobstructionisbetweentheprojectorandremote
control.
–Makesureyouarenottoofarfromtheprojectorwhenusingthe
remotecontrol.Maximumoperatingrangeis16.4'(5m).
–Wirelessremotecontroldoesnotworkwhentheremotecontrol
cableisconnectedtotheprojector.(seepage13)
–Makesurethecodeoftheremotecontrolisconformedtothe
projector’scode.Seepage53.
–UnlocktheKeylockfunctionfortheremotecontrolfunction.See
page54.
–CheckRESET/ON/ALL-OFFswitchontheremotecontrolissetto
“ON”.Seepage15.
Indicator blinks or lights. –Checkthestatusoftheprojectorwithreferringto"Indicatorsand
projectorCondition".(seepage69)
Wireless Mouse function does –Checktheconnectionbetweenaprojectorandyourcomputer.
not work. –Checkthemousesettingonyoucomputer.
–Makesurethemousedriverisinstalledonyourcomputer,
otherwise,theremotecontrolcannotbeusedasawirelessmouse.
–Makesurethesignalisfromthecomputer,otherwise,theremote
controlcannotbeusedasawirelessmouse.
–Turnontheprojectorbeforeturningonthecomputer.
The exclamation mark appears –Youroperationisinvalid.Operatecorrectly.
on the screen.
Top control does not work. –Thetopcontrolisnotavailableifthetopcontrolislockedat"Key
lock"under"Security"ofSETTINGsection.Pleasecheck"SETTING"
sectiononpage54.
Unable to unlock the Logo PIN –Contactthedealerwhereyoupurchasedtheprojectorortheservice
code lock, Security key lock center.
or Security PIN code lock.
Downloaded From projector-manual.com Sanyo Manuals

Table of Contents

Other manuals for Sanyo PLC-XU115

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sanyo PLC-XU115 and is the answer not in the manual?

Sanyo PLC-XU115 Specifications

General IconGeneral
Projection distance0.93/11.47 m
Vertical scan range50 - 100 Hz
Horizontal scan range15 - 100 kHz
Projection technologyLCD
Contrast ratio (typical)500:1
Projector native resolutionXGA (1024x768)
Keystone correction, vertical-40 - 40 °
I/O portsSD Card Slot
Audio input1
Aspect ratio4:3
Special featuresSoft Carry Bag
Networking featuresEthernet & Wireless
F-number (relative aperture)1.7
Lamp typeNSH
Lamp power275 W
Light source typeLamp
Service life of light source2000 h
Service life of light source (economic mode)3000 h
Dot clock scanning frequency140 MHz
Analog signal format systemNTSC, PAL, SECAM
Serial interface typeRS-232
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Power consumption (typical)266 W
Weight and Dimensions IconWeight and Dimensions
Package weight3500 g

Related product manuals