82
Available Features
– Store up to 4 identifiers
– Access 1 of the 4 identifiers
directly using the numeric keys
– Up to 20 characters per identifier
– You can assign this function to
the fourth or fifth soft key (from the
right), i.e. F4 or F5
– Press the ID soft key to display
an identifier
– You can configure when
the identifier is included on the
printout (see “Preparation,”
this page)
– Press Delete to delete
an identifier
– Optional configuration in the
Setup menu to delete a single
character of an identifier by
pressing c. Basic settings:
Keypad: CF function for input:
Delete last character
Identification Codes
Purpose
With this function you can assign
identifiers to values for
documentation and printouts.
You can use this function in
combination with a program from
Application 1 (e.g., counting,
weighing in percent), one from
Application 2 (checkweighing, time-
controlled functions) and one from
Application 3 (totalizing, formulation,
statistics).
Factory Settings
Printout:
Each time the print
key is pressed
Soft Key Functions
ID Toggle to “Identification
codes” menu
Delete Delete input of selected
identifier
Preparation
§ Turn on the scale: Press e/[ON/OFF]
> Sartorius logo is displayed, self-test is performed
§ Select Extra function (F4) or Extra function (F5) in the Setup menu:
Press M
§ Select the Application menu: App soft key
§ Select Extra func. (F4) or Extra func. (F5)
§ Select Identification codes
§ Confirm Identification codes
§ Select and confirm:
– Printout:
Automatic, if configured or
Once aft.pressing Print, if config. or
Each time the print key is pressed or
Once for M+ func. (app.3 memory)
see also the “Application Menu (Overview)” in the chapter entitled
“Configuring the Scale”
§ Save settings and exit the Setup menu: Press M
To Next Page
Loading...
Need help?
General