Satel CSP-208 - Page 37

SATEL Installation and Programming Manual 35
3. Press the button (enabling/disabling the fire alarm routing output) or the button
(enabling/disabling the fault warning routing output).
4. Press the button.
5. Using the and buttons, enable or disable the routing output. The ON LED
indicates (only one LED can be ON) that:
1 – routing output enabled;
2 – routing output disabled.
6. Press the button to save the changes made.
13. Enabling / disabling the automatic sounder restore option
1. Using the buttons , select the function 13 (see: Table 1, p. 29).
2. Press the button.
3. Using the and buttons, enable or disable the option. The ON LED indicates (only
one LED can be ON) that:
1 – option is enabled;
2 – option is disabled.
4. Press the button to save the changes made.
14. Programming the verification time
1. Using the buttons
, select the function 14 (see: Table 1, p. 29).
2. Press the
button.
3. Using the buttons , specify the verification time (see: Table 4, p. 32 – the 10 minutes
value cannot be programmed).
4. Press the
button to save the changes made.
15. Enabling / disabling panel support
1. Using the buttons , select the function 15 (see: Table 1, p. 29).
2. Press the button.
3. Press the button (enabling/disabling support of the repeater panel) or the button
(enabling/disabling support of the virtual panel).
4. Press the button.