Satel EASy+ - Page 48

SATEL-EASy+
User guide
Version 1.33
47
Default value: OFF
Repeater
Repeater Mode selects whether the radio modem forwards the
received messages over the radio or not.
Addressing must be also used in the systems that include more
than one repeater, in order to prevent the messages bouncing
between the repeater stations.
Default value: OFF
SL commands
SL command mode ON/OFF
When enabled, the modem can be configured/controlled by
using the SL commands.
Default value: ON
Priority
TX or RX
Default value: TX
FullCR16 Check
ON/OFF
Default value: OFF
LCD Mode
Normal (factory default)
- Allows the user to read and change the parameters via push
buttons and LCD display
Read-only
- Allows the user to read the parameters from the display but
modifying them is possible only via configuration software
SURV
- Selectable parameters via LCD UI: channel, compatibility,
Repeater -mode, FEC –mode. NOTE! Channel list forced ON.
Channel list parameters must be configured properly. See
chapter 12, Channel List for detailed information
SURV Read-only
- Allows the user to read the SURV parameters from the display
but modifying them is possible only via configuration
software
Add RSSI to data
If the function is ON, RSSI information is appended to the
received data. RSSI info "\02RSSI:-nnn dBm\03\0D\0A" in the end
of serial port messages, nnn is three digit decimal number.
Default value: OFF
Region Code
Region code defines the regional settings that firmware uses.
US: Starting from the 1st of Jan 2013 FCC regulations state, they
will allow transmission on 25 kHz radio channels only if the link
rate of the radio is at least 19200 bps.
In case Region code is set to US and the active setup violates
above mentioned FCC requirement, the radio modem cuts the
transmitter power level to zero (0 W) when transmitting. The