SATO HT200e - Page 103

SECTION 5 ： PRESET, TABLE DATA
SATO HT200e Page 5-11
REGISTRATION FOR TABLE DATA
[FNC1]
[ENTR]
[ENTR]
[ENTR]
[ENTR]
ＦＯＲＭＡＴ Ｎｏ
1［
・ ・］
ＨＴ２００ｅ
ＴＡＢＬＥ ＳＴＯＲＩＮＧ
2
Ｔ Ａ Ｂ Ｌ Ｅ １ ＴＡＢＬＥ２
ＴＡＢＬＥ３
ＴＡＢＬＥ１
3
Ｓ Ｔ Ｒ ＭＯＤＩＦＹ ＤＥＬ
ＳＴＲ ＴＡＢＬＥ Ｎｏ
4［
・ ・・ ］
ＣＯＰＹ ＦＲＯＭ［ ・・・ ］
［ＴＡＢＬＥ１］
5
・ ・・・・・・・・・・・・・・・
・・・・・・・・・・・・・・・・
The screen for the selection of data registration
area will be displayed: Press [ENTR], so that it
goes to the selection for table data registration.
Press [FNC1], so that it goes from the modes of
the print of format to the table data.
The screen for the selection of table data registra-
tion will be displayed: Press [ENTR], so that it
goes to the entry of table number.
Table No. can be entered: Press [ENTR], so that it
goes to the entry of table data. Whereas [SHFT]
or [ ↓ ] is pressed, it goes to the entry of number
for the copy table, which displays the table data
already registered when entry is required.
Table data can be entered: Enter table data, and
press [ENTR], so that one table data will be regis-
tered. Note that since the table No. will automati-
cally be counted and returned to the entry of table
number, be sure to repeatedly enter when continu-
ous input is required.