SATO HT200e - Page 109

SECTION 6: ON LINE
Page 6-4 SATO HT200e
2. Data regulating print position
This command specifies value that regulates print position.
<M>
･ [ 1B (H), 4D (H) ] nnn ････ n (32 bytes can be designated.)
E
S
C
M
Designation
for vertical
size of paper
Designa-
tion for
horizontal
size of
paper
Type
of
paper
Regulation of
vertical
position
Regulation of
horizontal
position
Name of
format
Name of
label
1 2 3 4 5 6 7 8 9 10 11 12 13 to 22 23 to 32
Digit
position
Item Description
1 to 3
Designation for vertical size of
paper
It is displayed in “mm”.
4 to 5
Designation for horizontal size of
paper
It is displayed in “mm”.
6
Type of paper It can select from the following:
1: NORMAL (Non-gap label for HT200e)
2: OPTION (M32 label)
7
Regulation of vertical position
(Direction)
It designates direction that can be fine adjusted for print.
Value; 1:+, 0: -
8 to 9
Regulation of vertical position
(Volume of migration)
It designates unit for dot in numbers. 1 dot = 0.025mm
10
Regulation of horizontal position
(Direction)
It designates direction that can be fine adjusted for print.
Value; 1: +, 0: -
11 to 12
Regulation of horizontal position
(Volume of migration)
It designates unit for dot in numbers. 1 dot = 0.025mm
13 to 22
Name of format It specifies name of each format.
23 to 32
Name of label It specifies name of label for each format.
[Direction that print position can be controlled]
Direction of paper to be forwarded
Up to 5mm or 40 dots in all directions can be
controlled. Note: Some position of print may
vary the number of dot that is adjustable.
Ver. -
Hori.
-
+
+