SATO HT200e - Page 69

SECTION 4 ： FREE MODE
Page 4-6 SATO HT200e
FIELD SETTING FOR SEQUENTIAL NUMBER
Based on the field designation, the setting, in which “12: Normal/Sequential Number” is specified,
is described.
Note 1: For the position of rotation, see 1. in Additional Information for Parameter.
Note 2: When horizontal direction is enlarged, space between characters will increase.
Note 3: Copy from the field of sequential number to the field is not allowed.
Digit
position
(s)
Designated item Description
1, 2 Field designation 12: Normal/Sequential Number
3 Font selection 0: X1 (20 x 50 dots)
1: X2 (
8 x 20 dots)
2: X3 (13 x 21 dots)
4: OCR-B(20 x 24 dots)
4, 5, 6 Vertical position 001 to 784 dot (s): Vertical print position
000: Entry only, where print is not required.
7, 8, 9 Horizontal position 001 to 384 dot (s): Horizontal print position
10 Rotation position
(Note 1)
0: 0° 2: 180°
1: 90° 3: 270°
11 Character pitch
(Note 2)
0 to 9 dot (s)
12, 13 Character count 01 to 08: Number of characters in the field
14 Vertical expansion 1 to 4: Magnification of vertical direction to character
15 Horizontal expansion 1 to 4: Magnification of horizontal direction to character
Input Check Digits
16 Input check 5: Numeric only
6: Numeric in all digits
8: Numeric and uppercase in English only
9: Numeric and uppercase in English in all digits
17 Function for sequential
number
0: Invalid
1 to 9: Valid for the table of sequential number
18 Reserved 0: Determined
19 0 insertion in
numbering sequence
0: Without 0 insertion
1: With 0 insertion
20 Preset 0: No entry in printing preset (Not displayed)
1: Entry in printing preset (Displayed)
21 Reserved 0: Determined