SATO HT200e - Page 82

SECTION 4 ： FREE MODE
SATO HT200e Page 4-19
DISPLAY ON THE SCREEN FOR FORMAT/TABLE DATA FIELD.
Field No. Position of digit
It will go to the entry for character pitch.
Note: Use [FMT] to return to the entry of the format number to be registered.
Press [ENTR] to determine the data selected, so that the screen for entry can be appeared.
０１ ０１ : ＦＬＤ ＴＹＰＥ ▽
1 １ : ＮＯＲＭＡＬ
０ ０００００００００００００００
０１ ０２ : ＤＡＴＡ ＴＹＰＥ▽
2 ０ : ＮＯＲＭＡＬ
１
０ ００００００００００００００
０１ ０３ : ＦＯＮＴ ＴＹＰＥ
3０:Ｘ１ １:Ｘ２ ２:Ｘ３ ▽
１１
０ ０００００００００００００
０１ ０４ : Ｖ－ＰＯＳＩＴＩＯＮ
4
１１２
０００００００００００００
０１ ０７ : Ｈ－ＰＯＳＩＴＩＯＮ
5
１１２０２５
０ ０００００００００
０１ １０ : ＲＯＴＡＴＩＯＮ
6０:０°１:９０° ▽
１１２０２５０３２
０ ００００００
Enter “1” for the field type.
Enter “0” for the data type.
Value in one digit can be entered for the character type.
Select the value from “0”, “1”, “2”, and “4”.
Value in 3 digits can be entered for the vertical position:
Select the values from “001” to “784”.
Note: “000” is a field where only entry is required, so
that no print is made.
Value in 3 digits can be entered for the horizontal
position: Select the values from “001” to “384”.
Value in one digit can be entered for the rotation:
Select the value from “0”, “1”, “2”, and “3”.