SATO HT200e - Page 87

SECTION 4 ： FREE MODE
Page 4-24 SATO HT200e
It will go to the entry for copy.
０１ １１ : ＣＨＡＲ ＰＩＴＣＨ
7
２０２０２５０３２０
２ ０００００
０１ １２ : ＣＨＡＲ ＣＯＵＮＴ
8
２０２０２５０３２０２
０ ００００
０１ １４ : Ｖ－ＥＸＰＡＮＳＥ
9
２０２０２５０３２０２０８
０ ００
０１ １５ : Ｈ－ＥＸＰＡＮＳＥ
10
２０２０２５０３２０２０８１
０ ０
０１ １６ : ＩＮＰＵＴＣＨＥＣＫ
11 ５ : ＮＵＭ ＯＮＬＹ ▽
２０２０２５０３２０２０８１１
０
０１ １７ : ＩＮＰ ＭＥＴＨＯＤ
12 ０ : ＬＥＦＴ １ : ＲＩＧＨＴ
０ ０００００００００００００
０１ １８ : ＩＮＳＥＲＴＩＯＮ
13０:ＮＯＮ １:CM ２:CM＆．▽
０
０ ００００００００００００
０１ １９ : ０ ＡＵＴＯ－ＩＮＳ
14
０２
０ ０００００００００００
０１ ２０
:
ＰＲＥＳＥＴ＆ＣＭ
15
０
:
ＯＦＦ＋ＣＭ ▽
０２１
０ ００００００００００
０１ ２１ : ０ ＲＥＳＥＲＶＥＤ
16
０２１０
０ ０００００００００
Value in one digit can be entered for spacing between
characters: Select the value from “0” to “9”.
Value in 2 digits can be entered for the number of
characters: Select the values from “01” to “10”.
Value in one digit can be entered for the magnification
of vertical expansion: Select the value from “1” to “4”.
Value in one digit can be entered for the magnification
of horizontal expansion: Select the value from “1” to “4”.
Value in one digit can be entered for the input check:
Select the value from “5”, “6”, and “7”.
Value in one digit can be entered for the input method:
Select “0” or “1”.
Value in one digit can be entered for the presentation
method: Select the value from “0”, “1”, “2”, “5”, “6”, and
“7”.
Value in one digit can be entered for with or without
0 insertion: Select “0” or “1”.
Value in one digit can be entered for entering the preset
and switching Euro currency mark: Enter the value from
“0”, “1”, “8”, and “9”.
0: No entry, so that general currency mark is not shown.
1: Entry required, so that general currency mark is
shown.
8: No entry, so that Euro currency mark is not shown.
“0” is fixed. Press [ENTR].