SATO HT200e - Page 96

SECTION 5 ： PRESET, TABLE DATA
Page 5-4 SATO HT200e
PRINTING OF PRESET DATA
[RCL]
[ENTR]
[ENTR]
[ENTR]
[ENTR]
[ENTR]
Note: Where asterisk mark or “*” can be seen in the upper right on the screen, entry by scanner
can be made possible.
ＦＯＲＭＡＴ Ｎｏ
1［
・ ・］
ＨＴ２００ｅ
［ＰＲＥＳＥＴ］
2
Ｐ Ｒ Ｉ Ｎ Ｔ ＳＴＲ ＭＯＤＩＦＹ
ＤＥＬ ＤＵＭＰ ＭＡＳＴＥＲ
ＰＲＥＳＥＴ ＮＯ ．ＩＮＰＵＴ＊
3
・ ・・・ ＜ＰＲＩＮＴ＞
［ＩＴＥＭ ］
4
・ ・・・・・・・・
［ＰＲＩＣＥ ］
5￡
・ ・・・・・
［ＱＴＹ ］
6
・ ・・・
ＰＲＩＮＴＩＮＧ
7
Press [RCL], so that it goes from the modes of the
print to the preset.
The screen for the selection of preset printing will
be displayed: Press [ENTR], so that it goes to the
entry of preset number.
The preset No. that is required to print can be
entered: Press [ENTR], so that it displays the pre-
set data specified.
Since the contents of data differ, based on the
format number retrieved, press [ENTR] by
checking data in each field.
Enter the No. of paper within 4 digits, and press
[ENTR]. Note that neither 0 nor un-entry is
permitted.
Preset will start printing:
Note: where the No. of print becomes 0, it goes
back to the process No. 3.