SATO LC400e Series - ESC+LD User Download

224
12.17 System
Printer
CL408e/412e
M-8400RVe
CL608e/612e
M-5900RVe
M-10e
M-8485Se/90Se/60Se/59Se M-84Pro-2/3/6 LC408e/412e
12.17 ESC+LD User Download
ESC+LD
HEX Code
ESC
LD
Parameter
<1B>16
<4C>16<44>16
, a, b, c, d, e, f, g, h, i, j
Default Value
Refer to the following table
Valid Range &
Terms of
Command
When Power is Switched Off
The set parameter is maintained
Valid Range within Items
The set parameter is valid until the next specification is made.
Valid Range between Items
The set parameter is valid until the next specification is made.
[Function]
To set the availability of Auto Online, 0 Slash and optional Protocol and Euro Code
[Format]
<LD>,a,b,c,d,e,f,g,h,i,j
● Parameter
Parameter content is indicated as follow
Function Parameter Content
Default
Standard
Non-Standard
Protocol Code
a(HEX)
STX
02H
{(7BH)
b(HEX)
ETX
03H
}(7DH)
c(HEX)
ESC
1BH
^(5EH)
d(HEX)
ENQ
05H
@(40H)
e(HEX)
CAN
18H
!(21H)
f(HEX)
NULL
00H
~(7EH)
g(HEX)
Offline
40H
](5DH)
Auto Online
h(ASCII)
0:YES 1:NO
0(30H)
0(30H)
0 Slash
i(ASCII)
0:YES 1:NO
0(30H)
0(30H)
Euro Code
j(HEX)
D5H
D5H
D5H
[Coding Example]
<A>
<LD>,{,},%,#,&,=,~,0,0,<FF>
16
<Z>
[Supplementary Explanation]
1.User Download Specification <LD> is used by mark off the Data Send Start Specification <A> ~ Data Send End Specification <Z>.
2.User Download Specification <LD> is valid only at Protocol Register Mode. Details of Protocol Code Register Mode can be referred to Operation
Specification.
3.Part of or entire parameter input can be omitted by comma. However, comma cannot be omitted. The omitted setting becomes default status (similar as
present).
4.When the number of comma inside of parameter is not at 10, and when specified code is found at other control command and print data, motion is not
guaranteed
User Download