[Function]
To specify registration of graphic pattern data
[Format]
<GI>abbbcccdddn~n
● Parameter
a {HEX or Binary Send Selection} = H : HEX Data
B : Binary Data
HEX Data (divide 8 bit data into 4 bit data, output as a HEX code that supports ASCII)
Binary Data (output 8 bit data as 1 character data)
b {specify graphic area of horizontal direction with byte unit} = refer to the following table
c {specify graphic area of vertical direction with byte unit} = refer to the following table
d {register number}(used as identity number during call-out) = valid range : 1~999
n {Data} = Graphic Data
[Coding Example]
<A>
<CC>1
<GI>H003003001n~n
<Z>
[Supplementary Explanation]
1.Specify the register data only during registration.
2.Registration changes required to re-register once it is cleared from Clear Command <*>.
3.Data which is registered by Graphic Register Specification <GI> is printed by using Graphic Re-Call Specificaiton <GR>.
4.Normal print may not be performed if it is not registered properly. Data format can be referred to Graphic Print Specification <G>.
5.Error occurs if re-register with a registered number. The re-registered content will be printed out and continue with the next process.
6.When Graphic Register Specification <GI> is used, Card Slot Specificatin <CC> shall be specified before this command.
7.LC408e/412e does not support optional memory card. Please specify {Flash ROM} with Card Slot Specification <CC>.
[Specified Range]
LC408e, CL408e, M-8400RVe,
M-84Pro-2
To Next Page
Loading...
