SATO LC400e Series - ESC+&R Form Overlay Re-Call

236
13.5 Memory Card
Printer
CL408e/412e
M-8400RVe
CL608e/612e
M-5900RVe
M-10e
M-8485Se/90Se/60Se/59Se M-84Pro-2/3/6 LC408e/412e
13.5 ESC+&R Form Overlay Re-Call
ESC+&R
HEX Code
ESC
&R
Parameter
<1B>16
<26>16<52>16
,aa
Default Value
NIL
Valid Range &
Terms of
Command
When Power is Switched Off
The set parameter is not maintained
Valid Range within Items
The set parameter becomes invalid
Valid Range between Items
The set parameter becomes invalid
[Function]
To specify re-call content which is registered in memory card by Form Overlay Register Specification <&S>.
[Format]
<&R>,aa
● Parameter
a {Register Number} = valid range : 1~99
[Coding Example]
<A>
<CC>1
<&R>,1
<Z>
[Supplementary Explanation]
1.Before the Form Overlay Re-Call Specification <&R>, slot number from Card Slot Specification <CC> shall be specified.
2.Form Overlay Re-Call Specification <&R> can perform printing with the combination of different register number.
3.When register number is not specified, the function of Form Overlay Re-Call Specification <&R> becomes invalid.
4.It will become read / write error if non-registered number is specified.
5.When non-specified window is registered, Print Vertical Position Specification <V> and Print Horizontal Position Specification <H>
will be ignored and re-call the drawing area from the beginning (V1, H1).
6.When Window is specified and registered, it is valid to move by specifying Print Vertical Position Specification <V> and Print Horizontal
Position Specification <H>. However, if it exceeds print area, the exceeded area will not be printed out.
7.Form Overlay Re-Call Specification <&R> cannot be used without the memory card.
8.LC408e/412e does not support optional memory card. Please specify {Flash ROM} with Card Slot Specification <CC>.
Form Overlay Re-Call