SATO LC400e Series - ESC+BW Barcode Print from Ratio

95
9.6 Barcode
Printer
CL408e/412e
M-8400RVe
CL608e/612e
M-5900RVe
M-10e
M-8485Se/90Se/60Se/59Se M-84Pro-2/3/6 LC408e/412e
9.6 ESC+BW Barcode Print from Ratio
ESC+BW
HEX Code
ESC
BW
Parameter
<1B>16
<42>16<57>16
aabbbn~n
Default Value
NIL
Valid Range &
Terms of
Command
When Power is Switched Off
The set parameter is not maintained
Valid Range within Items
The set parameter becomes invalid
Valid Range between Items
The set parameter becomes invalid
[Function]
To specify barcode that is registered at Barcode ratio Registration Specification <BT>
[Format]
<BW>aabbbn~n
● Parameter
a {Thin Bar Width} = valid range : 01~12 (dot)
b {Barcode Height} = valid range : 001~999 (dot)
n {Print Data} = barcode data
[Coding Example] Thin Bar Width:02, Barcode Height:120
<A>
<BT>103060306
<V>100<H>200<BW>02120*ABCD*
<Q>2
<Z>
[Supplementary Explanation]
１． NW-7, CODE39, Industrial 2 of 5, Matrix 2 of 5 is valid for barcode character pitch specification.
For specification method, by specifying right before Character Pitch Specification <P>, it becomes Barcode Character Pitch
Specification.
To omit, the width is as similar as thin space width.
e.g.1) When narrow space value is specified at 3 at Barcode Ratio Registration Specification <BT>
Character Pitch Specification (NIL or 0.3) X Thin Bar Width (2) = Character Pitch (6 dot)
e.g. 2) When Character Pitch is specified
Character Pitch Specification (2) X Thin Bar Width (3) = Character Pitch (6 dot )
2.When Barcode Ratio Registration Specification <BT> is not available, print the barcode with the ratio of narrow and wide bar that is
registered before hand. However, the barcode will not be printed if Barcode Ratio Registration Specification <BT> is not carried
out in advance.
3. Print data of barcode type can be referred to individual barcode code table.
[Point]
1.It becomes command error and will not be registered if data not within specification is set.
2.Printing may exceed print area when thin bar width is enlarged.
3.If the valid barcode of character pitch enlarge the Character Pitch <P>, it may not be read by the scanner. And the reading ratio will
become worse if thin bar width is enlarged. Details can be referred to the scanner specification.
4.Specify the thin bar width where the scanner reading condition shall put into consideration.
5.If it is unreadable, adjust Print Speed Specification <CS> and Print Darkness Specification <#E>.
6.When NW-7 and CODE39 is specified, and if start/stop character is not included in the print data, although barcode will be printed
out but it is unreadable at the scanner.
Barcode Print Specification from Ratio