SATO LC400e Series - Page 234

234
Normally it is used only as number registration, by specifying the size of Window’s vertical as well as horizontal direction, enables it to move by
Print Vertical Position Specification <V> and Print Horizontal Position Specification <H> during re-call. If register area exceed the print area
because of the moving during re-call, the exceeded portion will not be printed out.
The moving details are shown as the following:
(1)Normal Specification (to register)
<A>
<V>100<H>100<P>2<L>0202
<XM>ABCD
<V>60<H>60
<FW>0808V800H400
<V>320<H>60
<FW>04H400
<CC>1
<&S>,1
<Z>
(2)When print specification is found after <&S>
<A>
<V>100<H>100<P>2<L>0202
<XM>ABCD
<V>60<H>60
<FW>0808V800H400
<V>320<H>60
<FW>04H400
<CC>1
<&S>,1
<V>200<H>100<OB>12345
<Z>
(3)When Window size is specified
Label Size Specification <A1> 800400, Window Horizontal Direction Size{200}, Vertical Direction Size{200}
<A>
<A1>800400
<V>100<H>00<P>2<L>0202
<XM>ABCD
<CC>1
<&S>,1,200,200
<Z>
Register image
Printing which is done before specifying <&S>
will be registered as Form Overlay.
Only this area will be registered
Print
ABCD
Label Feed Direction
A
B
C
D
400 dot
800 dot 200 dot
200 dot