79
[Supplementary Explanation]
1.To register external word of width 16 X height 16 dot into the internal memory.
2.Code which is specified at Registration Font Code Address combines itself with the “Kanji Code Mode” that is set in the printer, and then
specify address of either JIS Code or Shift JIS Code.
3.Area that has been registered before is valid for re-registration.
4.Register order of data is shown as follow.
5.If external word is registered inside of printer memory, it will be erased once printer power is turned OFF. In this case re-register is
necessary.
External Word File{16X16}
To register the above external word, D1 and D2 is formed by{00000001}and{10000000}respectively. Each D1 and D2 data becomes
<01>
16 and <80>16.
Onwards, as such D3 is <03>
16, D4 is <00>16, D5 is <3F>16, D6 is <FC>16, external word registration data becomes the specification of
<018003003FFC·····>
16 and until D32.
To Next Page
Loading...
