SATO LC400e Series - Page 86

86
(5)Formation of Check Digit
The check digit of each barcode is shown as following table.
[C/D Formation]
Barcode
Specification
Parameter
Barcode
Specification
Input Digit Print Digit and Content
3 JAN/EAN-13
12 digit
13 digit (barcode input data + C/D)
C/D calculation is done automatically by modulus 10.
13 digit
13 digit (barcode input data. Does not performed C/D check)
4 JAN/EAN-8
7 digit
8 digit (barcode input data + C/D)
C/D calculation is done automatically by modulus 10.
8 digit
8 digit (barcode input data. Does not performed C/D check)
C CODE93
Max 99
digit
C/D calculation is done automatically by modulus 47.
E
UPC-E
6 digit only
C/D calculation is done automatically by modulus 10.
G
CODE128
-
C/D calculation is done automatically by modulus 103.
H UPC-A
11 digit
only
12 digit (barcode input data + C/D)
C/D calculation is done automatically by modulus 10.
I
Standard
Carton
for ID
UCC/EAN128
17 digit
only
C/D calculation is done automatically by modulus 103.
*C/D refers to Check Digit
Barcode Rotate Printing
Barcode rotate printing is valid, however, when Serial 1 and Serial 2 is specified and rotated, print ink may spread due to the
Barcode enlargement ratio.
Parallel 1:Print in order direction
Parallel2:Print in order and opposite direction (rotate 180°)
Serial 1:Rotate order direction printing at 90° and print
Serial 2:Rotate order direction printing at 270° and print
1) When printing is performed by parallel 1 and 2, specify the enlargement ratio of bar width so that printing becomes 2 dot
above if the head density of narrow bar is at 8 dot/mm, 12 dot/mm, and 4 dot above if narrow bar head density is at 24 dot/mm.
(L shows enlargement ratio aginst the bar ratio)
Head Density
8 dot/mm
12 dot/mm
24 dot/mm
Bar Ratio 1:2
Above 2L
Above 2L
Above 4L
Bar Ratio 1:3
Above 2L
Above 2L
Above 4L
Bar Ratio 2:5
Above 1L
Above 1L
Above 2L
UPC-A/JAN/EAN
Above 2L
Above 2L
Above 4L
2)When printing is performed by Serial 1 and 2, specify the enlargement ratio of bar width so that printing becomes 3 dot above
if the head density of narrow bar is at 8 dot/mm, 12 dot/mm and 6 dot above if the head density of narrow bar is at 24 dot/mm.
3)When printing is performed by Serial 1 & 2, use it before print speed is reduced.
Head Density
8 dot/mm
12 dot/mm
24 dot/mm
Bar Ratio 1:2
Above 3L
Above 3L
Above 6L
Bar Ratio 1:3
Above 3L
Above 3L
Above 6L
Bar Ratio 2:5
Above 2L
Above 2L
Above 4L
UPC-A/JAN/EAN
Above 3L
Above 3L
Above 6L
※Order direction is a horizontal direction
to the label feed direction.