General information
4
V23C_09.13
SC4000 Pos 1
!! IT IS NOT AL-
LOWED TO TOW
SC4000 ON PU-
BLIC STREETS !!
Drawing 1.2
SC4000 single on minichassis.
Mast consists of cross
hatching structure
mast sections which
are assem bled one on
top of the other and
connected with the
mast screw sets. On one
side of the mast section
there is the rack.
Top cap is situated on
the top of the mast. It
works as a me chanical
stopping device.
Top cap is also used
as a hoist bracket when
hoisting the mast or the
whole
SCAN CLIMBER
SC4000. The maxi mum
hoisting ca pacity of the
top cap is 5500 kg.
The freestanding height
of mast, assem bled
onto the wheel chas-
sis, is limited. By using
the anchoring system
it is possible to reach
the maximum height of
100 m. The minichassis
has been designed for
the narrow and close
worksites.
MINI CHASSIS
!
WALL ANCHOR
(VERTICALLY
ADJUSTABLE)
20-0295-102-1
Wheel chassis consists of a welded frame with
four wheels, four telescopic out riggers can be
turned out with levelling jacks, used for setting
the chassis and mast in ver tical po sition. Chas-
sis drive unit is available for the wheel chassis
to make the movements at worksite easier.
Towing of the SCANCLIMBER SC4000 at work-
site is possible with a tow bar.
LEVELLING JACK
To Next Page
Loading...