SCANCLIMBER SC4000 - Optional Equipment

Technical information
8
V23C_09.13
SC4000 Pos 2
1591 mm /5’3’’
1350 mm /4’5’’
834 mm/2’9’’
1550 mm /5’1’’
1791 mm /5’11’’
Drawing 2.5 Minichassis with di mensions.
2.2. OPTIONAL EQUIPMENT
Wheel chassis can be replaced by mini-
chassis. If this replacement is needed,
the instructions below should be fol-
lowed.
1. Shorten the platform to 4,1 m.
2. Remove the mast top cap.
3. Assemble one mast section.
4. Switch on the main current switch
5. Drive the platform to the height of
 therstandthesecondmast
section.
6. Assemble the mast top cap.
7. Switch off the main current switch
8. Remove the bottom limit switch
counter part.
9. Remove the bottom fasten
ing piece of the signalling bar.
10. Put on the lifting hooks to both
lift ing loops of the mast top cap.
11. Tighten the chains / cables of the
lifting hooks.
12. Loose the screws of the bottom
mast section.
13. After the mast screws have been
loosed the platform is lifted onto
the minichassis and fastened with
mast screws.
14. Assemble the bottom limit switch
counter part.
15. Assemble the bottom fastening
piece of the signalling bar.
.
WARNING !
TIGHTEN THE LIFTING CA BLES PROPERLY
TO PREVENT PLATFORM FROM FALLING
WHEN THE MAST SCREWS ARE LOOSED.
2.2.1. MINICHASSIS
!