SCANCLIMBER SC4000 - Transfer with Chassis Drive Unit

10
OPERATIONAL INSTRUCTIONS
V23C_09.13
SC4000 Pos 5
The transfer to the following work site can be done with platform lowered down to
its transport position and with max. 2 mast sections. The transfer can be achieved
by 2 persons.
Following steps have to be done:
5.3 2. TRANSFER WITH CHASSIS DRIVE UNIT
S4 - PUSH-BUTTON - FORWARD
S5 - PUSH-BUTTON-REWARD
S6 - EMERGENCY STOP
X6 - PLUG
Q1 - MAIN SWITCH
X1 - SUPPLY SOCKET
X3 - SOCKET
Drawing 5.7. Pendant control E3
(horizontal/vertical drive).
-X1
-X3
+OP1
-Q1
-X6
+E3
-S6
-S4
-S5
.
• Lower the platform on the rub-
ber buffers by manual lowering.
• Put the clutch lever to horizon-
tal drive position. Note that the
chassis has no brakes when the
clutch lever is in towing position.
• Turn the outriggers out.
• Keep the jacks as near the
ground as possible.
LEVER POSITIONS
HORIZONTAL DRIVE
TOWING
• Connect the pendant controller
to the chassis electric box con-
nector X3.
• Connect the power supply ca-
ble to chassis electric box socket
X1.
• Turn the chassis electric box
main switch Q1 to position 1.
• The platform moves forward
pushing the up-button S4 and
backwards pushing the down-
button S5 on pendant controller
E3.
• The chassis is steered by the tow-
ing bar.
After relocation:
• Turn the outriggers out.
• Lower the jacks.
• The lower safety limit shall be by-
passed when lifting the platform
from rubber buffers. The bypass
switch is in the platform electric
box.