SERVICE INSTRUCTIONS
3
SC4000 Pos 6
V23C_09.13
1. Maintenance of the load-bearing steel structure
The load-bearing steel structure of the platform should be subject to a special
care during loading, transport, unloading, storing, assembly and disassembly.
It is forbidden to use damaged elements.
Do not damage weldings and screw joints.
All parts should be protected against corrosion.
2. Maintenance of the lifting mechanism
The maintenance of the lifting mechanism requires very accurate and careful
services.
Pay attention to the following maintenance activities:
- the fastening of the lifting gear to the assembly plate
- the fastening of the assembly plate to the lifting frame
- protect all the lifting mechanism elements against corrosion.
Follow the instructions given by the gearmotor manufacturer on chapter 9.
3. Maintenance of the safety brake
The maintenance of the safety brake consists of:
- control the fastening of the safety brake to the assembly plate
4. Maintenance of the electrical equipment
All damaged or worn electric wires must be replaced.
6.1. PLATFORM MAINTENANCE
6. SERVICE INSTRUCTIONS
NOTE! THE SAFETY BRAKE MUST BE REPLACED WITH A NEW ONE
EVERY FOUR (4) YEARS.
NOTE!
ALWAYS BEFORE OPENING THE ELECTRIC CENTRE OF THE CHASSIS, PLAT-
FORM OR TWIN PLATFORM, THE MAIN VOLTAGE HAS TO BE SWITCHED OFF
WITH THE MAIN SWITCH Q0 AND Q1OR IT HAS TO OTHERWISE BE CAREFULLY
SE CURED THAT THE EN ER GIZED POINTS WILL NOT BE TOUCHED.
!
!
To Next Page
Loading...