ERECTION AND DISMANTLING
44
V23C_09.13
SC4000 Pos 4
After the completion of the assembly and before taken into use, a technical
inspection of the platforms has to be carried out. It is obligatory to check the
operation of the platform mechanisms and systems in the scope specied
below by an authorized inspector:
4.7. THE CHECK OF ASSEMBLED
PLATFORM
1. Connect the supply cable to the wall
socket X1.
2.
Connect the plug X6 of the pendant
control box E3 to the socket X3 on
the chassis electric box.
3. Switch on the main switch Q1 on the
chassis electric box.
Control light H1 must burn.
4. Switch on the main switch Q2 on the
platform electric box.
5.
Press the button S2 on the platform
elec tric box.
Warning signal should signalize.
6. Press by turns the buttons S4 ”UP” and
S5 ”DOWN” on pendant control E3,
Platform should move to corre-
sponding direction.
When lowering the platform to the
bottom position the hooter turns on
and stays on until the platform has
stopped automatically.
7.
Press the emergency stop S6 when
driving to any direction and the plat-
form should stop immediately.
Check the connections of all mast
sections, which should be tight ened
with a torque of 350 Nm.
Procedure
Scope of check
NOTE!
The platform moves as long as
the pendant control button is
pushed
!
1. Checking of the pendant control
E3.
To Next Page
Loading...