SC4000
SC4000
SIGNATURES /DAY:________________MONTH:____________ YEAR:_____________
_____________________________ ________________________________
PERSON IN CHARGE PERSON IN CHARGE
(ERECTOR) (ORDERER)
10.1.1294 (E1)
WORKSITE:_______________________________________________________________________________
TYPE OF MACHINE:____________________________________________ SERIAL NO:________________
PLATFORM LENGTH:____________________MAX. LIFTING CAPACITY:_________ HEIGHT:__________
ERECTION COMPANY:____________________________________________________________________
PERSON IN CHARGE:___________________________________ __________ TEL.:____________________
ORDER COMPANY:______________________________________________________________________
PERSON IN CHARGE:_____________________________________________ TEL.:____________________
CHECK POINT OK REMARKS
1. GROUND PLATES UNDER JACKS AND BEARING CAPACITY OF THE GROUND
2. OUTRIGGERS FULLY TURNED, EXTENDED AND LOCKED WITH PIN
3. JACKS SCREWED DOWN AGAINST GROUND PLATES
4. PLATFORM AND MAST ARE VERTICALLY AND HORIZONTALLY ADJUSTED
5. CENTRE JACK: SC4000 ALWAYS, SC1300 MAST HEIGHT > 30M
6. PLYWOOD BOARD ON TELESCOPIC EXTENSIONS (MIN. 22 MM)
7. DISTANCE BETWEEN PLATFORM AND WALL (MANUAL CHAPTER 4.)
8. CHECKING THE RAILINGS ASSEMBLY
9. MAST GUARD NET ASSEMBLED
10. MAST SECTION BOLTS TIGHTENED -350 Nm
11. COUNTERPARTS FOR LIMIT SWITCHES (TOP AND BOTTOM)
12. TOP CAP ASSEMBLED
13. FUNCTION OF THE EMERGENCY STOP
14. FUNCTION OF THE PUSH-BUTTONS UP AND DOWN
15. FUNCTION OF THE LIMIT SWITCHES (TOP, BOTTOM, MAST ASSEMBLY)
16. FUNCTION OF THE EMERGENCY LOWERING
17. FUNCTION OF THE PLATFORM LEVELLING DEVICE (TWIN)
18. WALL ANCHORING (MANUAL CHAPTER 4.))
19. FASTENING OF THE ANCHORING BOLTS -190 Nm
20. LATTITUDE OF THE GUIDING ROLLERS
21. MEASURING THE ELECTRIC POWER SUPPLY IN CABLES
22. ELECTRIC CABLES ARE HANGING FREE AND STRAIGHT
23. RACK AND PINION CONTACT
24. FUNCTION OF THE SAFETY BRAKE
25. PLATFORMS STATIC AND DYNAMIC TEST (MANUAL CHAPTER 4.)
26. NO VISIBLE PLATFORM DAMAGES
27. FUNCTION OF THE ELECTROMAGNETIC BRAKES
28. NO UNUSUAL NOISE FROM MECHANISMS AND MOTORS
29. NO OIL LEAKS FROM GEAR BOXES
30. RACKS ARE CLEAN AND LUBRICATED
31. WORKSITE FENCED OFF
32. EXPIRATION DATE OF THE SAFETY BRAKE. THE BRAKE MUST BE REPLACED
(OVERHAULED AT THE FACTORY) EVERY FOUR (4) YEARS
33. UNIT FREE FROM UNNECESSARY EQUIPMENT
34. ASSEMBLY OF POSSIBLE WEATHER COVER
35. OPERATORS HAVE GOT ENOUGH INFORMATION AND TRAINING IN THE USE OF THE UNIT
36. HANDBOOK AVAILABLE
37. ALL SIGNS AND LABELS POSITIONED AND READABLE
ERECTION FORM
To Next Page
Loading...