EasyManua.ls Logo

SCANCLIMBER SC4000 - Instructions;Warnings for Operators

SCANCLIMBER SC4000
166 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OPERATIONAL INSTRUCTIONS
3
SC4000 Pos 5
V23C_09.13
- Operator must be authorized and trained for the operation.
- Become acquainted with the operating instructions.
- Follow the safety regulations.
- Inspect the carrying capacity of the ground.
- Place the outriggers properly and lock with pin.
- Always use wooden ground plates under the jacks.
- Regulate the mastclimber horizontally and vertically.
- Make the daily inspections, chapter 5.
- Use signal hooter before starting.
- Do not exceed load and height limits.
- Distribute the load evenly.
- The load is not allowed to hang over the railings.
- Do not cause any lateral forces by pulling or pushing.
- Do not use the mastclimber when wind speed exceeds
12,7 m/s freestanding
15,5 m/s mast anchored
- Guard railings and mast guard net must be secured.
- Pay attention to the operation temperature.
- Do not lean over platform guard railings.
- Do not use ladders or scaffolds on the platform.
- Be careful with the electric cables nearby.
- Be careful with the obstacles on the work site.
- Do not use faulty machine.
- Do not work if your physical condition is not well.
- Inform of any suspected faults.
- Prevent the unauthorized use of the platform.
- Provide adequate lighting for safe operation.
5. OPERATIONAL INSTRUCTIONS
5.1. INSTRUCTIONS/WARNINGS
FOR THE OPERATORS

Table of Contents