ERECTION AND DISMANTLING
6
V23C_09.13
SC4000 Pos 4
Read carefully the anchoring in structions shown on the following drawings
4.1 - 4.7.
Also carefully read through the loading ta bles.
4.5. WALL ANCHORING
INSTRUCTIONS
B
A
F1
F2
F1
Drawing 4.1. Anchoring forces.
When choosing the size of the
anchoring screw and the an-
choring distance, the quality
of the wall as the responsibility
of the builder, has to be con sid-
ered.
!
The anchoring force indicates how much
one anchoring has to hold.
Manufacturer of the anchoring screws is
obliged to inform the pull-out strength of
the anchoring screws.
Anchoring forces appearing on one an-
choring set (anchoring distance 12.5 m)
is shown on the following drawings.
See the gures of A/B and F1/F2 on the
table 20-0895-1206.
To Next Page
Loading...