SCANCLIMBER SC4000 - Page 104

ERECTION AND DISMANTLING
26
V23C_09.13
SC4000 Pos 4
!
!
WARNING!
THE USE OF THE PLATFORM IS FOR-
BIDDEN WITHOUT TESTED SAFETY
BRAKE!
WITH POSITIVE RESULT:
- switch off the main switch Q1
- disconnect the test pendant con trol
E4
- release the safety brake according
to the instructions b)
WITH NEGATIVE RESULT (SAFETY BRAKE
DOESN´T ENGAGE):
- lower platform to the bottom po-
sition,
- switch off the main switch Q1,
- dismount the safety brake, send it
for repair to the manufacturer and
af ter wards reassemble or replace
it with a new one, and repeat the
test
b) RESETING THE SAFETY BRAKE
- Open the two screws (2) of
the bronze nut (3) with 10
mm wrench.
- Open the safety brake
cover (1) with 10 mm
wrench.
1
2
3
Evacuate the platform during the
test.
The test is to be carried out by
trained or authorized person
only.