3
STORAGE AND TRANSPORT
SC4000 Pos 7
V23C_09.13
Check that:
7. STORAGE AND TRANSPORT
This instruction applies to storage of the platform in dismantled condition for a
period of 30 days or longer. Before storing the following actions should be taken:
- clean and wash all main component units of the platform,
- cover with consistent grease layer all parts machined and not painted,
- store all smallerloose parts and units of the platform in appropriate
place protected against weather changes by oiling,
- store electrical equipment in separate place,
- place platform component units in place assigned for this purpose - best of
all under the roof - and protect the place against access of un au thorized
persons.
In case of longer storage time, check the external condition of all platform com po-
nent units occa sionally.
7.2. TRANSPORT INSTRUCTION
7.1. STORAGE INSTRUCTION
When disassembling SC4000 for transport, don´t forget to lower the
platform onto the rubber cushion of the chassis with help of the emer-
gency lowering levers at the end of the lifting gear motors.
ATTENTION!
!
•
There are no loose equipment on the machine,
•
The electric cable isn´t squeezed.
•
During the transport the maximum load of a 7,4 m longplatform is
900 kg, evenly distributed. Platform must be supported e.g. with
wooden beams.
•
Always tighten the vertical outriggers against the transport
carriage.
•
Fasten carefully.
To Next Page
Loading...