3.1 Working notes 15
3 Working method, purpose
3.1 Working notes
Usual progress of a work step
The frame formwork cleaner SB10B is designed for cleaning frame formwork.
Loading the frame formwork cleaner with a frame formwork.
Fully automatic cleaning.
Remove the frame formwork.
The work steps repeat afterwards.
3.2 Intended use
The frame formwork cleaner SB10B is intended for:
Cleaning of frame formwork within the adjustable width and height.
The maximum dimensions of the frame formwork to be cleaned must not exceed the dimensions
(see chapter 4.1 Technical data, page 16) of the machine.
3.3 Non-intended use
For non-intended use, improper treatment and when the machine is operated by untrained or
unauthorised persons, the machine may cause danger to the staff and the machine. Therefore,
only trained, instructed and charged persons must operate this machine. Non-intended use of this
machine means, among others:
Non-observance of the notes and instructions in the operating instructions regarding
transport, assembly, commissioning, operation, maintenance and equipment of the ma-
chine
Operation of this machine with defective safety facilities.
Independent constructional changes.
Independent changes at the machine's drive.
Improperly performed repairs
Disasters due to external effects and force majeure
Use in automatic operation (programme-controlled operation) by control change.
3.4 Prohibitions
Modification or deactivation of safety devices.
Operation of this machine with defective safety facilities.
Painting over or removing signs, notes, etc.
Operation of this machine by unauthorised and uninstructed persons.
To Next Page
Loading...