EasyManuals Logo

Sea-doo 2004 3D RFI Shop Manual

Sea-doo 2004 3D RFI
89 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
Section 02 MAINTENANCE
Subsection 04 (STORAGE)
Seal Carrier
Remove rear access cover.
Lubricate seal carrier of drive shaft support with
synthetic grease. Stop lubricating when grease is
just coming out of seal.
F22J05A
1
1. Grease seal carrier
FUEL SYSTEM
Inspect fuel hoses. Replace damaged hoses or
clamps if necessary.
Sea-Doo Fuel Stabilizer (P/N 413 408 600) or equiv-
alent should be added in fuel tank to prevent fuel
deterioration. Follow manufacturer's instructions
forproperuse.
CAUTION: Fuel stabilizer should be added
prior to engine lubrication to ensure fuel sys-
tem components protection against varnish
deposits.
Fill up fuel tank completely. Ensure there is no
water inside fuel tank.
CAUTION: Should any water be trapped inside
fuel tank, severe internal damage will occur to
the fuel injection system.
WARNING
Fuel is inflammable and explosive under
certain conditions. Always work in a well
ventilated area. Do not smoke or allow open
flames or sparks in the vicinity. Fuel tank
may be pressurized, slowly turn cap when
opening. When fueling, keep watercraft lev-
el. Do not overfill or top off the fuel tank and
leave watercraft in the sun. As temperature
increases, fuel expands and might overflow.
Always wipe off any fuel spillage from the
watercraft. Periodically inspect fuel system.
COOLING SYSTEM FLUSHING
AND ENGINE INTERNAL
LUBRICATION
Cooling system has to be flushed with fresh water
to prevent salt, sand or dirt accumulation which
will clog water passages.
Engine must be lubricated to prevent corrosion on
internal parts.
For proper procedure, refer to FLUSHING AND
LUBRICATION in the Shop Manual. Follow in-
structions for RFI models.
NOTE: On the 3D RFI, the hose adapter is located
on the right hand side on the jet pump support.
F22J01A
1
1. Hose adapter
6 smr2004-3D
www.SeaDooManuals.net

Table of Contents

Other manuals for Sea-doo 2004 3D RFI

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sea-doo 2004 3D RFI and is the answer not in the manual?

Sea-doo 2004 3D RFI Specifications

General IconGeneral
BrandSea-doo
Model2004 3D RFI
CategoryBoat
LanguageEnglish

Related product manuals