Section 02 MAINTENANCE
Subsection 04 (STORAGE)
Insert a funnel into the temporary hose and pour
antifreeze in engine until the colored solution ap-
pears at the cooling system bleed outlet. Use a
container to recover the water/antifreeze.
F07E0LA
TYPICAL
F22L0HA
1
COOLING SYSTEM BLEED OUTLET
1. Recover water/antifreeze from this outlet
Place a container at rear of watercraft to recov-
er the water/antifreeze from the vehicle hose
adapter.
Remove the 2 hose pinchers from the engine drain
hoses.
Most of the antifreeze will drain out when remov-
ing the hose pinchers. Use a container to recover
it. DISPOSE ANTIFREEZE AS PER YOUR LOCAL
LAWS AND REGULATIONS.
Expansion Pipe and Muffler
Disconnect the tuned pipe water supply hose at
T-fitting.
F22E06A
1
1. Disconnect hose from T-fitting
Insert a funnel into the hose.
Raise the hose as high as possible and pour 1.2 L
(1.3 U.S. qt) of antifreeze.
CAUTION: It is important to keep the hose as
high as possible so the antifreeze can reach the
end of the expansion pipe.
Reconnect hose to the T-fitting.
Complete Cooling System
NOTE: For the above engine and exhaust sys-
tem procedures, although most of the antifreeze
drained out, it has mixed with any water in the wa-
ter jackets.
At preseason preparation, flush out the remaining
antifreeze from cooling system prior to using the
watercraft.
ANTICORROSION TREATMENT
Refer to STORAGE in the Shop Manual.
8 smr2004-3D