EasyManua.ls Logo

Sea-doo 2004 3D RFI - Safety Check List

Sea-doo 2004 3D RFI
89 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Section02MAINTENANCE
Subsection 01 (PERIODIC INSPECTION CHART)
PERIODIC INSPECTION CHART
The schedule should be adjusted according to operating conditions and use.
NOTE: The chart gives an equivalence between number of hours and months/year. Perform the mainte-
nance operation to whatever time comes first.
IMPORTANT: Schedule for watercraft rental operations or higher number of hour use, will require greater
frequency of inspection and maintenance.
DESCRIPTION
INTERVAL
I
: Inspect, verify, clean, adjust, lubricate.
Replace if necessary
C
:Clean
L
: Lubricate
R
: Replace
FIRST
10
HOURS
EVERY
25 HOURS
OR
3MONTHS
EVERY
50 HOURS
OR
6MONTHS
EVERY
100 HOURS
OR
1YEAR
GENERAL
Lubrication/corrosion protection (1) L
ENGINE
Support and rubber mount I I
Seals and fasteners I I
Exhaust system fasteners (5) I I
Expansion pipe I
RAVE valve (5)
C C
Counterbalance shaft oil level
I I
Spark plug (5)
I(4) R
Ignition timing (5) I
COOLING SYSTEM
Flushing
C(3)
Hose and fasteners I I
Engine drain tubes I(1)
FUEL SYSTEM
Throttle cable (1) I
Fuel injection system sensors (except throttle body) (5) I I
Throttle body and TPS (5) I I
Fuel lines, fuel rail, fittings, check-valve, relief valve
and fuel system pressurization (5)
I I
Air intake silencer fit/tightness I I
Fuel tank straps I I
smr2004-3D 1
www.SeaDooManuals.net

Table of Contents

Other manuals for Sea-doo 2004 3D RFI

Related product manuals