Seatex DPS 200 - Page 70

Seatex DPS 200 Installation Manual, rev. 4 Appendix D - DPS setup file
58
! IMPORTANT NOTE: LINK 1 IS FOR IALA BEACON ONLY !!!
!
[DiffCorrLinks]
DIFFCORR_LINK_1 com3 4800 n 8 1 nh
DCLNK1 NAME IALA
DCLNK1 TYPE RTCM
DCLNK1 SHORT RANGE 1
DCLNK1 ROLL BYTES 1
DCLNK1 6 OF 8 BITS BYTE 1
DCLNK1 DEBUG 0
DCLNK1 ENABLE_GLONASS_CORR 0
DCLNK1 IONOSPHERE COMPENSATED 0
DCLNK1 REF STATION OFFSET 0.0 0.0 0.0
DIFFCORR_LINK_2 com5 9600 n 8 1 nh
DCLNK2 NAME LINK 2
DCLNK2 TYPE SCF
!DCLNK2 TYPE RTCM
DCLNK2 SHORT RANGE 0
DCLNK2 ROLL BYTES 1
DCLNK2 6 OF 8 BITS BYTE 1
DCLNK2 ENABLE_GLONASS_CORR 1
DCLNK2 IONOSPHERE COMPENSATED 0
DCLNK2 REF STATION OFFSET 0.0 0.0 0.0
DCLNK2 SHOW_CONSOLE 0
DIFFCORR_LINK_3 com6 9600 n 8 1 nh
DCLNK3 NAME LINK 3
DCLNK3 TYPE SCF
!DCLNK3 TYPE RTCM
DCLNK3 SHORT RANGE 0
DCLNK3 ROLL BYTES 1
DCLNK3 6 OF 8 BITS BYTE 1
DCLNK3 ENABLE_GLONASS_CORR 1
DCLNK3 IONOSPHERE COMPENSATED 0
DCLNK3 REF STATION OFFSET 0.0 0.0 0.0
DCLNK3 SHOW_CONSOLE 0
!--------------------- GYRO INTERFACE AND DECODING ----------------------------*
! Stuff for GYRO interface & decoding
! Comm parameters: nh:no handshake, sh:software handshake, hh:hardware handshake
! GYROIO_x TYPE options:
! NMEA_HDT = NMEA heading format
! LR22_BCD = Robertson LR22 BCD format
! GYROINTERFCONSOLE : Enable gyro console window if set to 1
[Gyro]
GYRO_SENSOR_1 com7 9600 n 8 1 nh
GYROIO_1 TYPE NMEA_HDT
GYROINTERFCONSOLE_1 0
!---------------------------- VESSEL INFO ------------------------------------*
! *
! The vessel info covers vessel dimensions, antenna position and *
! point offset vectors. *
! *
!------------------- Vessel dimensions ---------------------------------------*
! The following parameters define the vessel to be drawn in TMS: *
! VESSEL NAME <name> <name> is a string which may contain spaces *
! VESSEL LENGTH <length> Length of vessel [m] *
! VESSEL WIDTH <width> Width of vessel [m] *
! VESSEL SHAPE <width> Vessel shape (SHIP, RIG or JACKUP) *
!
[VesselDimensions]
FSP ref.: A11213500XRBRA0