Secutron MR-2300T - Page 74

74
11.3.8 Command Menu/MR-2300 Config -->Default Configuration
1.Indicating zone label
|
|
|
4.
[NAC-1 ]->Default
[NAC-4 ]->Default
BYPASS SWITCH TRANSLATION
KEY SEQ 1 2 3 4 KEY SEQ 1 2 3 4
--------------------------------------
Zone-1
0 Q Z Zone-2 1
Zone-3 2 A B C Zone-4 3 D E F
Zone-5 4 G H I Zone-6 5 J K L
Zone-7 6 M N O Zone-8 7 P R S
Zone-9 8 T U V Zone-10 9 W X Y
Zone-11 Back Space Zone-12 Forward
Note: Refer to section 11.2.1 on page 64 for detailed instructions on making menu
selections.
Press the up and down arrow buttons to select
between Y/N. Press ENTER to restore the
default configuration.
Use this menu to load the default configuration in
the panel.
Warning: When you load the default
configuration, the previously programmed
configuration is lost permanently.
NAC-1 Label
NAC-1
NAC-4 Label
NAC-4
i
Load the default
settings? Y
Default settings
have been loaded