The fault records are saved (in a power-fail-safe manner) within the Fault Recorder. If there
is no more memory free, the oldest record will be overwritten (FIFO). Up to 10 records can
be stored.
It is always the last (newest) fault that pops up on the DiggiMEC display. By pressing
the »↵« key (“OK”) the overlay/pop-up is closed, but will re-appear with the next restart.
Press the »Reset« key or use the Direct Control »Rst. LEDs, FIs, Flt.Scr.« to close
it permanently.
180 WIC1 WIC1-1.0-EN-MAN
5 Fault Recorder
5.1 Fault Display screen (Overlay / Pop-up) on the DiggiMEC
To Next Page
Loading...
