Sega AV F-ZERO AX - 19-2 Removing the Game Board (TRIFORCE)

− 155 −
TABLE18.5
Theseat'smotionis
unsatisfactory.
Noresponsefrom
Steering(Servomotor).
UnsatisfactoryAcceland
Brakeoperation.
Incompletepoweroncheck.
Deviationofthevolumevalue.
Volumegearengagementfault.
Volumemalfunctioning.
Detachedwires.
Thesensorisbeingtriggered.
Thesensorismalfunctioning.
Failureofpower-onchecking
procedure.
Faultyconnectorconnections.
ThermalelementintheServomotoris
operating.
Momentaryoverloadcausedafuseon
theServodrivertoblow.
Incorrectvolumesetting.
FaultyVolumeattachmentoradjust
gearalignment.
Faultyconnectorconnection.
Failureofthevolume.
Poweronandverifythatthepoweroncheck
completesproperly.(See5ofSection6.)
AdjustthecalibrationintheTestMode.
(SeeSection10.)
Adjusttheengagementofthegear.
(SeeSections10,11&12.)
Replacethevolume.(SeeSections11&12.)
Checkforfaultywireconnectionsaround
movingparts.
Whenreplacingwires,securethemsothat
theydonottouchanymovingparts.
Checktoseeifthereareanyobjectsblocking
thesensor.
GointoTestmodeandchecktomakesurethe
sensorisfunctioningproperly.(SeeSection
10.)
Reconnectthepowerandcompleteapower-
oncheckingprocedure.(See5ofSection6.)
Checktheconnectionsfortheconnectors
betweentheGameBoardandServodriverand
betweentheServodriverandtheServomotor.
Occurswhentheinternaltemperaturereaches
70°C(158°F)andcorrectsautomatically
whentheunitcools.
Contactthecompanyfromwhomtheunitwas
purchased.
AdjustthevolumevalueintheTestMode.
(SeeSection10.)
Adjustthevolumeattachmentandverifyin
TestMode.(SeeSections10&13.)
ChecktheconnectionsfortheAcceland
Brakeconnectorsandtheconnectorsbetween
theAccel,BrakeandCabinet.
Replacethevolume.(SeeSection13.)
PROBLEM CAUSE COUNTERMEASURES