10
Turn off the power switch.
11
Remove the DVD wire and software installation from the DVD DRIVE.
12
Attach DVD DRIVE case lid and fasten it with 1 thumbscrew.
13
Remove the 2 truss screws, unlock the left side front door with the master key, and then take it off.
14
Disconnect the DVD wire and software installation from the RINGWIDE.
15
Refer to Step 2 in 6-5 “PREPARING FOR SOFTWARE INSTALLATION” to attach the hole lid.
16
Attach the left side front door, lock it with the master key, and fasten it in place with 2 truss screws.
17
Turn on the power switch.
18
Store the DVD DRIVE, DVD wire, software installation, and DVD software kit in a location free from
dust and cigarette smoke.
To Next Page
Loading...
